-
Suitable to measure dynamic air gauge pressure;
- Small size, M5×0.5 mounting;
- Measurement range absolute 500kPa,
- Response time≤20μs;
- Anti-shock>100g.
Pressure sensor MP500K, based on piezo resistance effect, includes a full bridge circuit. There is resistance changed by measurement air pressure different, then the voltage signal can be converted according to the resistance difference. The reasonable MEMS process makes sure the sensor good linearity performance and stability. The sensor includes wear-resisting cable with default length 8m. And the LEMO connector and Dallas ID are optional.
Technical Specification (5V, 25℃):
Name | Unit | Value |
Meas. Range | kPa | 500 |
Over Load | kPa | 750 |
Non-linearity | %FS | ≤±0.5 |
Response Freq. | kHz | DC-50 |
Offset | mV | <50 |
Span signal | mV | 75~125 |
Warm Up | ms | <50 |
Excitation Voltage | VDC | 5 |
Power Current | mA | <10 |
Anti-Shock | g | >100 |
Isolation | MΩ | >100 |
Operation Temp. | ℃ | -20~70 |
Storage Temp. | ℃ | -40~125 |
Case Material | / | Stainless Steel |
Weight | grams | 2.0 |
Dimension | mm | 9.1×14.0 |
Connector and ID as required;
Other mounting screws are optional.
Drawing Reference:
Wire Assignment:
Red | Excitation+ |
Black | Excitation- |
White | Signal- |
Green | Signal+ |
Shield | Connector Case |
![]() |
Pressure Sensor MP500K |